What the Pentagon's Cost and Pricing Transparency Memo Changes for Contractors
On October 1, 2026, the Department of War issued guidance that lets contracting officers request actual cost information from primes and suppliers. What it requires, what it expressly does not, and where it applies.
On October 1, 2026, the Department of War issued implementing guidance titled “Implementation of Supplier Cost and Pricing Transparency”. It allows contracting officers to request actual cost information from prime contractors and from their suppliers when they consider it necessary to determine a fair and reasonable price. The memo was signed by the Principal Director for Defense Pricing, Contracting, and Acquisition Policy. It implements two Deputy Secretary of War memoranda, dated August 18 and September 14, 2026, which are attached to it.
The memo applies at both the prime and the supplier level. Several parts of it are described in the memo itself as still to go through rulemaking, and the sections below mark them.
What does the memo change about cost data?
Contracting officers may request actual cost information at both the prime and the supplier level, excluding commercial off-the-shelf items, if they deem it necessary to determine a fair and reasonable price. The memo ties this to the hierarchy in 10 U.S.C. § 3705 and to FAR 15.402 and 15.403. The September 14 memorandum’s appendix directs that the implementing procedures provide for price information to be obtained first, and cost information to the extent needed to establish a fair price.
The memo limits the burden on the contractor in specific terms:
- Requests should generally be limited to data that is immediately available in the form the contractor regularly maintains. No new accounting system or special data format is required.
- Enterprise resource planning (ERP) data should be accepted where practicable.
- A request does not, by itself, require a cost-reimbursement contract, Cost Accounting Standards (CAS) coverage, or a right of access to records the contract does not already provide.
- Contractors subject to CAS continue to provide data from a CAS-compliant system. Contractors not subject to CAS provide it through a system that follows Generally Accepted Accounting Principles (GAAP).
If a contractor refuses a request, the contracting officer may pursue specific enforcement actions. Where certified cost or pricing data is required by statute and refused, the contracting officer must coordinate with the Defense Contract Audit Agency to start a Truth in Negotiations audit.
The August 18 memorandum, which this guidance implements, describes the transparency requirement as supporting negotiations for products and services valued at $10 million or more. The October memo itself frames requests as available when necessary.
What does the memo change about profit?
The memo directs contracting officers to tailor profit models with sector-specific benchmarks. The benchmarks inform negotiation objectives and are not caps. Margins are meant to reward efficiency, speed and performance, and for hardware and weapon systems to account for the contractor’s self-funded facilitization, non-recurring engineering investment and execution risk, not merely costs incurred.
Each kind of work has its own reference point. Hardware and weapon systems align with commercial manufacturing risk-to-reward ratios. Software and information technology services reflect commercial software-as-a-service margins and research and development investment. Services and sustainment follow commercial logistics and third-party maintenance rates, driven by performance-based metrics.
The memo describes the revision of the Defense Federal Acquisition Regulation Supplement profit policy as still to come: these principles will be put forward for industry feedback and formal rulemaking.
For sole-source and long-term production programs, the memo strongly encourages a “Tiered Profit-Sharing” approach. The contracting officer negotiates a realistic base profit margin and then shares profits from realized efficiencies over time, with the Department’s share taken as non-cash value such as later price reductions or additional deliverables. Where it is used with a prime contractor, the prime must flow down similar terms to its key suppliers.
What does the memo say about late cost reports?
For programs that require them, the memo reinforces enforcement of Cost and Software Data Reporting (CSDR). The memo describes CSDRs as generally required for Acquisition Category II and larger programs, for contracts and subcontracts valued greater than $50 million. For any contract with delinquent CSDR reports, the contracting officer must immediately issue a formal demand letter requiring submission within 30 days. If the contractor fails to comply, the contracting officer should, at a minimum, enforce the contract terms by applying withholds where the contract provides for them, until the deliverables are received.
The 30 days is the period the demand letter allows for submission. The August 18 memorandum separately directs that delinquent prime and subcontractor CSDR reports be submitted within 30 days of that memorandum.
Will the Department connect directly to contractor accounting systems?
The memo says the Department will study secure channels to automate push-only access to actual cost data from contractor financial systems. Any initiative that uses application programming interfaces (APIs) integrated with contractor ERP systems would go through formal rulemaking. If an API is pursued, contractor participation will be strictly voluntary, with no penalty for contractors who do not take part, and it will not be a condition of award, an evaluation factor, or a consideration in any responsibility determination.
The August 18 memorandum described establishing APIs to pull cost information directly from contractors’ ERP or other financial systems.
For the costs a new award requires before the first payment, see mobilization costs on a government contract and funding to hire for a new award. The Department’s companion guidance on fixed-price contracting is covered in fixed-price is now the default for federal contracts.
Need funding to hire employees and buy equipment for a new contract? Contact us.
Common questions
Does the memo apply only to large contractors? The memo does not distinguish by company size. It is addressed to Department of War contracting components and applies wherever a contracting officer deems cost information necessary to determine a fair and reasonable price, at both the prime and the supplier level. The August 18 memorandum it implements describes the transparency requirement as supporting negotiations valued at $10 million or more.
Is a new accounting system required? No. The memo states that no new accounting system or special data format is required, and that requests should generally be limited to data in the form the contractor regularly maintains.
Could the cost data a contractor provides reach a competitor? The memo says its approach seeks to minimize the exposure of a company’s proprietary business information to other competitors in the supply chain. The September 14 memorandum adds that data industry provides will be used only for authorized Government purposes and never made available to another company for its own use.
Is any of this a regulation? The memo is policy guidance. It says the profit principles will be advanced for formal rulemaking to revise the Defense Federal Acquisition Regulation Supplement profit policy. Any API initiative would also use formal rulemaking, and a new contract clause or data format would be pursued through the standard rulemaking process.
How is this different from certified cost or pricing data? Certified cost or pricing data is a statutory requirement under the Truth in Negotiations Act that applies above set thresholds. The September 14 memorandum states that asking for information does not alter those thresholds or exceptions. The cost information in this memo concerns the case where certified data is not required and a contracting officer cannot establish a fair price from competition, market pricing, sales data or other sources.
This article is for educational purposes only and does not constitute advice for your specific business.